Tidy up last page of assembly instructions.

[atreides.git] / assembly / assembly.tex

diff --git a/assembly/assembly.tex b/assembly/assembly.tex
index ffd29f5d0686c7ccf2490f75773d9b40c46e4a67..83a062fe97640187748a4bfae62f93b47773f432 100644 (file)
--- a/assembly/assembly.tex
+++ b/assembly/assembly.tex
@@ -295,6 +295,14 @@ iron, but getting a desoldering pump is much more effective.
 
 \vspace{1em}
 
+If there is room between the head of the USB cable and the place where
+the cable leaves the case, consider adding strain relief by wrapping
+the cable with electrical tape at the point just below where it leaves
+the case. This will make it so pulling on the cable does not dislodge
+it from the controller.
+
+\vspace{1em}
+
 After the switches are all in and tested, close the case by placing
 the switch plate on top of the spacer and bottom plate, placing the
 top plate on it, and screwing it together with the nuts facing up. If the
@@ -308,14 +316,11 @@ adhesive, white glue may be needed to secure them.
 \vspace{1em}
 
 All that's left is to place the keycaps. The larger keycaps go on the
-middle thumb keys.
-
-\vspace{1em}
-
-Congratulations. Enjoy your new keyboard. It will take a considerable
-adjustment period to get used to it, but it should result in much more
-comfortable and effective typing. Also remember that you're encouraged
-to customize the layout to make it truly your own. Happy typing!
+middle thumb keys. Congratulations. Enjoy your new keyboard. It will
+take a considerable adjustment period to get used to it, but it should
+result in much more comfortable and effective typing. Also remember
+that you're encouraged to customize the layout to make it truly your
+own. Happy typing!
 
 %% \noindent\makebox[\textwidth]{%
 %% \includegraphics[width=\linewidth]{finished.jpg}}